SilverCrest SSTME 600 B1 Mode D'emploi page 17

To remove stubborn dirt, you can remove the attachment A with the cutting
■
blades 4 from the blender jug 3:
Fig. 3
1) Remove the blender 3 from the motor block 6. For better stability, remove
the lid 2 by turning it anticlockwise towards the position
until you can pull it off upwards.
2) Turn the appliance upside down and turn the attachment A with the cutting
blades 4 anticlockwise so that it can be detached from the blender jug 3
(see fig. 3).
Handle the cutting blades 4 with extreme caution. They are very sharp.
►
3) Clean both parts thoroughly in a mild soap solution.
NOTE
If necessary, you can remove the sealing ring B from the attachment A with
the cutting blades 4. Pull the sealing ring B out of the attachment A and
clean it in a mild soap solution. Then rinse off the sealing ring B in fresh
water.
■ 14 │ GB │ IE
WARNING! RISK OF INJURY!
A
B
(see fig 1)
SSTME 600 B1