Cleaning Functions Steam Oven - Thermador Professional Série Guide D'utilisation Et D'entretien

Cleaning Functions Steam Oven

NOTICE: Do not use oven cleaner on the self-cleaning
surfaces. These will damage the surfaces. If oven cleaner
does get onto these surfaces, wipe it off immediately
using water and a sponge. Do not rub the surface and do
not use abrasive cleaning aids.
Your appliance is equipped with "Ecolytic Clean",
"Easy Clean" and a "Descale" function. The self-cleaning
surfaces in the oven cavity are cleaned with the
"Ecolytic Clean" cleaning function. Use the "Easy Clean"
function for intermediate cleaning of the oven cavity
bottom. Food and food spills are saturated with steam
enabling soils to loosen when using the "Easy Clean"
function and can then be removed more easily. You can
use the "Descale" function to remove limescale from the
evaporator.
Ecolytic Clean
Some surfaces in the oven cavity are cleaned with the
Ecolytic Clean operating mode.
Ecolytic cleaning is constantly cleaning. The side panels,
ceiling panel and back panel are coated with a porous,
matte ceramic material known as an ecolytic coating.
The coating absorbs and breaks down splashes over
time from baking, roasting and broiling while the oven is
in operation.
If the surfaces no longer clean themselves adequately
and dark patches appear, the surfaces can be
"refreshed" using the Ecolytic Clean mode which helps
clean the ecolytic coating by operating the unit at a
higher temperature to help speed the process.
Note: During normal operation the appliance records
the number of times it is used and indicates when it has
reached a point where cleaning is recommended. The
recommendation is displayed until the Ecolytic Clean
mode has finished.
If this function is not performed, then the ecolytic
surfaces may become damaged.
If your appliance becomes prematurely soiled or if you
notice dark patches on the back panel, do not wait until
your appliance recommends cleaning. The more often
the appliance is cleaned, the longer the porous surfaces
will retain their cleaning capability. You can clean your
appliance at any time needed using the Ecolytic Clean
function.
Wipe out large spills from the oven before running the
Ecolytic Cleaning function.
Do not clean parts or accessories in the self-clean oven.
Before Running the Ecolytic Clean Function
Remove racks, rails, accessories and ovenware from the
oven cavity.
Cleaning the Oven Bottom and the Inside of the
Appliance Door
Remove the worst food spills from the oven bottom, the
inside of the appliance door and the interior lighting.
Otherwise, patches will appear that cannot be removed.
NOTICE: Do not use oven cleaner on the ecolytic
cleaning surfaces. These will damage the surfaces. If
oven cleaner does get onto these surfaces, wipe it off
immediately using water and a sponge. Do not rub the
surface and do not use abrasive cleaning aids.
Start
Before setting the cleaning function, ensure that you
have followed all instructions for preparation.
Cleaning takes 1 hour. The duration cannot be changed.
Turn the function selector to CLEAN MODES.
1.
Swipe to the left or right to select "Ecolytic Clean
2.
Touch the bottom line.
3.
The cleaning time with Ecolytic Clean is displayed.
Touch the bottom line.
4.
After a few seconds the appliance starts Ecolytic
Clean. The remaining time appears on the display.
Keep the kitchen ventilated while the cleaning function is
running.
As soon as the cleaning aid has run through, a signal
sounds and the appliance ends the operation
automatically.
Once the Cleaning Function has Ended
Once the oven cavity has cooled down, wipe down the
oven cavity with a damp cloth if necessary.
Note: During operation and while the cleaning function
is active, reddish patches may form on the surfaces. This
is not rust, but food residues. These patches are not
hazardous to your health and do not limit the cleaning
capacity of the self-cleaning surfaces.
Easy Clean
The Easy Clean function makes it easier to clean the
oven floor. Food and food spills are soaked beforehand
by vaporizing the vinegar solution. It can then be
removed more easily.
WARNING
9
RISK OF SCALDING
Hot steam can arise due to water in the hot oven
cavity. Never pour water into the hot oven cavity.
Setting
The "Easy Clean " function can only be started once
š
the oven cavity is cold (room temperature) and the
appliance door is closed.
Do not open the appliance door during this operation.
Doing this will interrupt the "Easy Clean
Remove the accessories and racks from the oven
1.
cavity.
Turn the function selector to CLEAN MODES.
2.
Swipe to the left or right to select "Easy Clean
3.
Touch the bottom line.
4.
After a few seconds the appliance starts the Easy
Clean function. The remaining time appears on the
display.
".
™
" function.
š
".
š
37