Install The Pad (Rev) - Nilfisk Advance SC1500 Mode D'emploi

A - ENGLISH
INSTALL THE PAD (REV SYSTEM)
1 Make sure the Scrub Deck is in the RAISED position. Make sure the Key Switch (A) is off (O).
CAUTION !
Turn the key switch off (O) and remove the key, before changing the pad
2 See Figure 3. Rotate the Squeegee Assembly (10) away from your side of the machine to create better access to the pad, (AA).
3 Daily Scrubbing: Slide a daily scrubbing pad (AE) or Microfi ber Pad (AB) under the pad driver, center it on the fi xed pad driver (AC) and lift it upwards and
press it onto the harpoon face of the pad driver.
4 Floor Finish Removal: Install a new red pad (AE) to the pad driver (AC) as described in step 3 above. If using the optional double sided Velcro (AF), attach
it to the center of maroon SPP pad (AD) and slide this assembly under the red pad and center it and then press upwards to attach this assembly to the red
pad. If the optional double sided Velcro is not used, install a new red as described in step 3 above and place a new maroon SPP pad on the fl oor centered
on the red pad. Lower the deck to the fl oor on top of the maroon SPP pad and check that it is centered.
NOTE: Never attach a maroon SPP pad directly to the pad driver, damage to the pad driver will result causing replacement.
FIGURE 3
AE
AF
AD
A - 12
INSTRUCTIONS FOR USE
8
10
AA
SC1500 - 56091120
AC
AB
5/2014