Fracarro D-Matrix 4S Instructions D'emploi page 47

>USB; the USB configuration page opens as shown in figure 4.
Select the required file in FILE, then flag the ENABLE box. Click on SAVE to save the configuration.
If the file has never been used, the system analyses the format and bitrate to conduct an
automatic configuration, creating a file with the same name but an .FR extension, where the
analysis result is stored for future use.
The right section lock led should turn on green, showing that the file is being successfully read.
The transport run data are shown in the fields on the bottom right. During the pre-analysis,
which can take a few minutes if the file is very large, the "uploading" status is shown.
When a file is started and the "File OK" status is shown by the green led, the programs in the
selected file are added to the list of input programs and can also be added to the list of output
programs.
5.2.3 COMMON INTERFACE CONFIGURATION
The menu CONFIGURATION->COMMON INTERFACE->CAM1 / CAM2 is used to access the
CAM module configuration pages, inserted in their respective slots.
The name of the CAM in the slot is shown at the top. If there is no name or it is not correctly
initialized the message "No Module" appears.
Fig.4
Fig.5
47