Fracarro D-Matrix 4S Instructions D'emploi page 39

ENABLE: allows deciding whether to use the receiver connected to the selected input, if OFF is
selected the receiver is turned off.
TUNER: allows setting the decoder reception parameters.
SET FREQ.
DISEQC: allows setting the DiSEqC according to the satellite (A, B, C or D).
FREQUENCY
FREQ. (MHz): allows setting the extended frequency for the transponder to be received.
POLARITY: to set horizontal or vertical polarity.
TYPE LNB: to set the type of LNB
SET FREQ. IF
DISEQC: allows setting the DiSEqC according to the satellite (A, B, C or D).
FREQ.IF (MHz): allows setting the IF frequency for the transponder to be received.
TYPE LNB: to set the type of LNB
SYMBOL RATE: allows setting the symbol rate for the transponder to be received.
MEASURES
LOCK: to check whether the receiver has locked the signal.
NETWORK NAME: - reading only – shows the transponder name.
RF LEVEL (dBuV): - reading only – shows the input signal level.
BER: to view the BER (quality) of the input signal.
MER (dB): allows viewing the input signal MER.
INPUT USB: to manage the USB input as source for an audio/video signal in transport stream.
ENABLE: allows enabling or otherwise reading the audio/video files in an external
USB drive.
SELECT FILE: to select which file to be used in an external USB drive.
USB STATUS: shows the state of the selected file.
NB: D-Matrix only recognises and reproduces audio/video files in TS format and standard
definition, any other audio/video format must be converted beforehand using any of the
conversion software that can be found in the web.
39