Fracarro D-Matrix 4S Instructions D'emploi page 36

3.4 INSERTING CAM MODULES
To insert the CAM modules in the slots, position the module as shown in the figure and press it
lightly. The module should slide along the guides freely. If it does not, check they are correctly
aligned and the insertion direction.
To extract the CAM modules pull slightly to one side and the module should come out without
difficulty.
3.5 MULTICOLOUR STATUS LEDS
D-MATRIX 4S has four multicolour leds on the top (one for each input), to indicate the sat signal
reception status, and one multicolour led on the bottom showing the system status.
The following table gives a useful summary to interpret the lighted leds.
INPUT STATUS LED
Off: Input off
Orange: Input active waiting to lock
Green: Input active and locked
Red Input overloaded
SYSTEM STATUS LED (during initialisation)
Orange: Boot system
Red: Begin applications
Green: System started without error
SYSTEM STATUS LED (system started)
Green: Normal
Orange: Anomaly
Flashing red: Update and/or recovery phase
4. INSTRUCTIONS FOR USE
• Wait until the D-MATRIX is initialized (the display shows D-MATRIX FRACARRO)
• To access the panel menu, press V, type in the user code (default code is 1234) and confirm
by pressing V.
• Program as instructed below (see the paragraph Base programming from the panel).
• Check the output signal is available by using a field meter
• Connect the distribution cable to the output connector
A PC can be used alternatively to configuration from the panel, by accessing the programming
using a web interface (see the paragraph Programming by web interface).
36