Save Configuration - Fracarro D-Matrix 4S Instructions D'emploi

NETWORK:
ENABLE DHCP: (for expert users). To enable automatic management of network para
meter allocation, if the subnet has a DHCP service. It is deactivated as default.
NOTE: Do not enable the DHCP function if the network parameters have been set as indicated
below.
IP: input a compatible IP taken from the settings for the LAN network the D-Matrix
should be connected to (default 192.168.0.2)
NETMASK: use a netmask that is compatible with the subnet (default 255.255.255.0)
GATEWAY: gateway address of the subnet (default 192.168.0.1)
DNS: DNS server address, if it is available (default 0.0.0.0)
WEB SERVER PORT: enables changing the web communications port, by default it is
set on 80.
MAC ADDRESS: to view the address that uniquely identifies the device.
ATTENTION: after default resetting, these parameters are reinstated to those set in the factory.
LANGUAGE: to set the display language for the unit menus.
RESET: to restart the D-Matrix: this operation does not change the parameters set by the user.
SAVE CONFIGURATION: to copy the product configuration on a USB drive in .XML format.
Insert the USB drive in the product USB port before saving the configuration.
UPLOAD CONFIGURATION: to upload the product configuration from an .XML file stored on a
USB drive.
LCD CONTRAST: to regulate the contrast for better display.
CHANGE PIN: to change the PIN (default 1234) to access programming on the unit.
FACTORY CONFIGURATION: to reinstate the D-Matrix to the values set in the factory, deleting
all the changes made by the user.
UPDATE SW:
SOFTWARE RELEASE: to view the SW release installed in the D-Matrix.
UPDATE SOFTWARE: to update the system software, using an update package in
the USB drive. SW update outcome: to view the outcome of the SW update.
Start SW update: to run the SW update from a USB drive.
5.2 PROGRAMMING BY WEB INTERFACE
The device can be configured using the web interface.
After configuring the network parameters using the front panel and connecting to the local
network, or to a PC using a cross lead, the web browser can be used.
Example (direct configuration from a PC):
•Change the IP address using one that belongs to the same subnet as the one set in the local
net card on the PC:
Parameters set in the PC net card:
• IP: 192.168.0.3
• SUBNET MASK: 255.255.255.0
• GATEWAY: 192.168.0.1
Parameters to change in the D-MATRIX net settings:
• IP: 192.168.0.2
• SUBNET MASK: 255.255.255.0
• GATEWAY: 192.168.0.1
Connect the device to the PC using a UTP cross lead CAT-5E or higher
Start the web browser (recommended: Google Chrome, Mozilla)
44