Programming Instructions; Keypad Functions - Fracarro D-Matrix 4S Instructions D'emploi

If required, the product can be reset to the factory parameters (see the paragraph Factory
Settings).
ATTENTION: in this condition English is the default language.
After resetting the factory settings, the D-Matrix will have to be reprogrammed, as the preset
parameters may not coincide with the required ones.
For the default parameters, see chapter 5.5.
NB: The D-Matrix timeout is 5 minutes: after that time, in no other changes are made to the
program, the last saved configuration by the product or the factory configuration is reinstated.

5. PROGRAMMING INSTRUCTIONS

5.1 BASE PROGRAMMING FROM THE PANEL
D-MATRIX 4S can be programmed using the keypad and display directly from the front panel.
Press V to access the programming menu and input the user code (default code is 1234), then
confirm the code by pressing V again. Use the arrow up and down keys to move around the
menu and select the required parameter, press V to confirm and enter the selected parameter.
To exit the selection press X.
When viewing a parameter, use the arrow right and left keys to select the required value, then
press X to exit (no confirmation is required).
If required, use the numeric keypad to input a numeric value, then press V to confirm.
NB: The D-Matrix timeout is 5 minutes: after that time, in no other changes are made to the
program, the last saved configuration by the product or the factory configuration is reinstated.
The menu is available in various languages. To change the menu language, access the main
"LANGUAGE" menu, select the required language and press V to confirm.

KEYPAD FUNCTIONS

Arrow up / arrow down: To surf among the various menu items
Arrow left / arrow right: To select the parameter value
V: To confirm an input value or enter a submenu
X: To cancel an input value or to exit a menu
0 - 9: To input numeric values
S: To save the changes
37