Oven Light Replacement - IKEA UPPSEENDE Mode D'emploi

EN
3. Open the filter access door.
4. Remove the existing Carbon Filter (if installed) by
pulling forward out from the unit.
5. Place the new Carbon Filter
door at an angle until it's upright and securely placed
in the duct.
Carbon Filter
6. Make sure the
the slot. Close access door, tighten screw and the
Carbon Filter is ready to use.
V
into the slot behind the
is nested vertically in

Oven light replacement

To access the light cover remove the Carbon Filter per
instructions 1-4 above in the Carbon Filter re-placement
section.
1. Open light cover located behind Carbon Filter by
carefully pulling up on the front edge.
2. Remove the LED bracket and light assembly.
Remove the LED light from the bracket by removing
the mounting screw and replace only with part
5304499540.
To order parts call (833) 337-4006.
3. Re-install LED light to the bracket with mounting
screw. When re-installing mounting screw be careful
not to damage the LED light.
4. Reconnect LED light to the harness and place the LED
light assembly back into the plastic housing.
25