Initial Use - Siemens CT636LE Série Mode D'emploi

Masquer les pouces Voir aussi pour CT636LE Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

en

Initial use

General
Fill the appropriate container using only
pure, cold, uncarbonated water and solely
roasted beans (preferably espresso or
coffee bean blends for fully automatic coffee
machines)� Do not use coffee beans that
have been glazed, caramelised or treated
with other additives containing sugar, since
they will block the brewing unit�
Before the appliance can be
A
switched on and used, it must
be assembled and connected
according to the enclosed assembly
instructions�
Setting up the appliance
● Remove any protective plastic film.
Important: Only use the appliance
F
in a frost-free room� If it has been
transported or stored at tempera-
tures below 0°C, wait at least 3 hours
before initial use�
● Take hold of the appliance door by the
recessed grip and open�
● Remove the water tank, rinse it and fill it
with fresh water up to the "max" mark�
● Replace the water tank and click into
place�
● Remove the bean container, fill with
coffee beans and replace�
● Set the mains switch to I and close the
appliance door�
The appliance heats up and is rinsed�
The display is activated�
"Select language" appears�
● Turn the rotary selector to select the
desired language and touch [ Continue ]
in the display�
"Set water hardness" appears�
38
It is important to set the water hard-
F
ness correctly to enable the appli-
ance to accurately indicate when the
descaling programme should be run�
The preset water hardness is level 4�
If a water softener is installed in the
house, please set the water hard-
ness to level 3� You can also check
the water hardness by asking your
local water supplier�
● Use the enclosed test strip to determine
the water hardness. Briefly dip the test
strip in water and check the result after
one minute�
Level Water hardness
German (°dH) French (°fH)
1
1-7
2
8-14
3
15-21
4
22-30
● Turn the rotary selector to set the water
hardness determined�
● Touch [ Continue ]. "Complete set-up?"
appears�
● Touch [ Apply ]. The settings are saved�
The appliance is ready to use when the
drink symbols are shown on the display�
The integrated fan switches on each time
a drink is dispensed and switches off again
after a few minutes�
When the appliance is used for the first time
after running a service program, or if it has
not been operated for a long period, the first
beverage will not have the full aroma and
should not be consumed�
When the fully automatic coffee machine
is first used, a suitably thick and stable
"crema" is only achieved after the first few
cups have been dispensed�
1-13
14-25
26-38
39-54

Publicité

Table des Matières
loading

Table des Matières