Warning Icons And Error Codes; Meaning Of The Warning Icons - Philips Saeco Xelsis SM7686 Mode D'emploi

English
20
2 Remove the drip tray and the coffee grounds container, empty them and put them back
into place.
3 Remove the water tank and empty it. Then remove the AquaClean filter.
4 Pour the whole bottle of Philips descaler in the water tank and then fill it with water up to
the CALC CLEAN level. Then place it back into the machine.
5 Place a large container (1.5 l) under the coffee dispensing spout.
6 Follow the instructions on the screen to start the descaling procedure. The descaling
procedure lasts approx. 15 minutes and consists of a descaling cycle and a rinsing cycle.
7 Once the descaling cycle is finished, you need to rinse the water tank and water circuit.
Follow the instructions on the screen.
8 Place a new AquaClean filter in the water tank and reactivate the AquaClean filter in the
menu.
Tip: Using the AquaClean filter reduces the need for descaling!
What to do if the descaling procedure is interrupted
You can exit the descaling procedure by pressing the on/off button on the control panel. If
the descaling procedure is interrupted before it is completely finished, do the following:
1 Empty and rinse the water tank thoroughly.
2 Fill the water tank with fresh water up to the CALC CLEAN level indication and switch the
machine back on. The machine will heat up and perform an automatic rinsing cycle.
3 Before brewing any drinks, perform a manual rinsing cycle. To perform a manual rinsing
cycle, first dispense half a water tank of hot water and then brew 2 cups of pre-ground
coffee without adding ground coffee.
Note: If the descaling procedure was not completed, the machine will require another
descaling procedure as soon as possible.

Warning icons and error codes

Meaning of the warning icons

Fill the water tank with fresh
water to the MAX level
indication.
The bean hopper is empty. Put
new coffee beans in the bean
hopper.
Close the service door.
Close the lid of the bean hopper.