Philips Saeco Xelsis SM7686 Mode D'emploi page 23

Problem
The machine is in
DEMO mode.
The 'coffee grounds
container full' icon
remains displayed.
The 'coffee grounds
container full' icon is
displayed even though
the container is not
full.
I cannot remove the
brew group.
I cannot insert the
brew group.
The coffee is watery.
Cause
You pressed the standby
button for more than 8
seconds.
You emptied the coffee
grounds container while the
machine was switched off.
You placed back the coffee
grounds container too fast.
The machine did not reset
the counter the last time you
emptied the coffee grounds
container.
The brew group is not in the
correct position.
You have not removed the
coffee grounds container.
The brew group is not in the
correct position.
The brew group is dirty or
needs to be lubricated.
Solution
Switch the machine off and then on
again with the main switch on the
back of the machine.
Always empty the coffee grounds
container while the machine is
switched on. If you empty the coffee
grounds container when the
machine is switched off, the coffee
cycle counter is not reset.
Do not place back the coffee
grounds container until the screen
prompts you to put it back.
Always wait approx. 5 seconds when
you place back the coffee grounds
container. In this way the coffee
grounds counter will be reset to zero.
Always empty the coffee grounds
container while the machine is
switched on. If you empty the coffee
grounds container when the
machine is switched off, the coffee
grounds counter will not be reset.
Reset the machine in the following
way: place back the drip tray and the
coffee grounds container. Then close
the service door and switch the
machine off and back on again. Try
again to remove the brew group.
Remove the coffee grounds
container before you remove the
brew group.
Reset the machine in the following
way: place back the drip tray and the
coffee grounds container. Leave the
brew group out. Close the service
door and switch the machine on and
off. Then put the brew group in the
correct position and reinsert it into in
the machine (see 'Reinserting the
brew group').
Clean and lubricate the brew group.
English
23