Warning Icons - Philips 1200 Série Mode D'emploi

Masquer les pouces Voir aussi pour 1200 Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
18

Warning icons

Warning
Solution
icon
The 'water tank empty' light is on
-
-
The 'empty coffee grounds container' light is on
-
The alarm light is on
-
-
The alarm light is flashing
-
-
The alarm light is on and the start light flashes.
Some air is trapped inside the machine.  To release the air from the machine, fill the
water tank with water, place a cup under the classic milk frother and press the
flashing start/stop button.
Be careful: small jets of hot water will be dispensed from the classic milk frother to
release the air.
AquaClean light is flashing: place or replace the AquaClean water filter and activate
it. See chapter 'AquaClean water filter' for step-by-step instructions.
Descaling light is flashing slowly: Descale the machine (see 'Descaling procedure (30
min.)').
The lights in the drink icons light up and go out one by one.
The machine is heating up and/or trying to release the air that was drawn into the
machine. Wait until all drink lights light up continuously.
The water tank is almost empty. Fill the water tank with fresh water to the
maximum level indication.
The water tank is not in place. Place back the water tank.
The coffee grounds container is full. Remove and empty the coffee grounds
container while the machine is switched on. Wait at least 5 seconds before you
reinsert the container.
The coffee grounds container and/or the drip tray is not in place or not placed
correctly. Place back the coffee grounds container and/or the drip tray and make
sure they are in the correct position.
The service door is open. Remove the water tank and make sure the service door
is closed.
The brew group is not in place or not placed correctly. Remove the brew group
and make sure it is locked into place. See chapter 'Removing and inserting the
brew group' for step-by-step instructions.
The brew group is blocked. Remove the brew group and rinse it with water under
the tap. Then lubricate the brew group and place it back into the machine. See
chapter 'Cleaning and maintenance' for step-by-step instructions.

Publicité

Table des Matières
loading

Table des Matières