Ce Declaration Of Conformity - Nice Road400 Instructions Et Avertissements Pour L'installation Et L'utilisation

Masquer les pouces Voir aussi pour Road400:

Mode d'emploi (158 pages)

Table des Matières

Les langues disponibles

Declaration in accordance with the following Directives: 1999/5/EC (R&TTE), 2004/108/EC (EMC);

Note - The content of this declaration corresponds to that specified in the official document deposited at the Nice S.p.A. headquarters

and, in particular, to the latest revised edition available prior to the publishing of this manual. The text herein has been re-edited for editorial

purposes. A copy of the original declaration can be requested from Nice S.p.A. (prov. of Treviso), Italy

Number: 297/Road400

Manufacturer's Name:

Address:

Person authorized to draw up

technical documentation:

Type of product:

Model / Type:

Accessories:

The undersigned Mauro Sordini, as Chief Executive Officer, hereby declares under his own responsibility that the product identified above

complies with the provisions of the following directives:

• DIRECTIVE 1999/5/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 9 March 1999 on radio equipment and telecom-

munications terminal equipment and the mutual recognition of their conformity, in accordance with the following harmonised standards:

- Health and safety (Art. 3(1)(a)): EN 62479:2010

- Electrical safety (Art. 3(1)(a)): EN 60950-1:2006 + A11:2009+A12:2011

- Electromagnetic compatibility (Art. 3(1)(b)): EN 301 489-1 V1.9.2:2011, EN 301 489-3 V1.6.1:2013

- Radio spectrum (Art. 3(3)): EN 300 220-2 V2.4.1:2010

• DIRECTIVE 2004/108/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 15 December 2004 on the approximation of

the laws of the Member States relating to electromagnetic compatibility and repealing Directive 89/336/EEC, in accordance with following

harmonised standards: EN 61000-6-2:2005, EN 61000-6-3:2007

In addition, the product conforms to the following directive in accordance with the provisions applicable to partly completed machinery:

Directive 2006/42/EC OF THE EUROPEAN PARLIAMENT AND COUNCIL of May 17 2006 regarding machines and amending directive

95/16/EC (consolidated text)

• I hereby declare that the pertinent technical documentation has been drafted in accordance with Annex VII B of Directive 2006/42/EC and that the following

essential requirements have been fulfilled: 1.1- 1.1.2- 1.1.3- 1.2.1-1.2.6- 1.5.1-1.5.2- 1.5.5- 1.5.6- 1.5.7- 1.5.8- 1.5.10- 1.5.11

• The manufacturer agrees to send the national authorities pertinent information on the partly completed machinery, in response to a motivated request,

without affecting its intellectual property rights.

• If the partly completed machinery is operated in a European country with an official language other than the language used in this declaration, the importer

must include a translation with this declaration.

• The partly completed machinery must not be operated until the final machine in which it is to be incorporated is declared to conform to the provisions of

Directive 2006/42/EC, if applicable.

The product also complies with the following standards:

EN 60335-1:2012, EN 60335-2-103:2003

The parts of the product which are subject to the following standards comply with them:

EN 13241-1:2003, EN 12445:2002, EN 12453:2002, EN 12978:2003 + A1:2009

Oderzo, 09 May 2014