Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL BT-CS 500 Mode D'emploi D'origine

Anleitung_BT_CS_500_SPK1:_
GB
are covered.
Switch on the tool and wait for a few seconds for
the blade to reach operating speed.
Press the locking button (7) and, applying a little
pressure, slowly lower the tool into the
workpiece. If the overload display (2) lights up,
reduce the speed.
Push the saw forwards through the workpiece.
Never cut backwards!
If the overload display (2) lights up, reduce the
speed.
If the tool stops and the overload display (2)
lights up continuously, the overload cut-out has
triggered. Reasons: The feed speed was too
high or there is an obstruction in the workpiece.
In this case, switch off the tool and check the
workpiece. Continue at a reduced feed speed.
Exert only little pressure on the tool when cutting.
The base plate must always lie flat on the
workpiece.
6.3 Switching ON/OFF (Fig. 1)
Switching ON/OFF (Fig. 1)
To switch on:
Push the switch (1) forwards and hold.
To switch off:
Release the switch (1).
Important. Carry out a trial cut in a piece of
waste wood
6.4 Changing the saw blade (Fig. 1-2/5-6)
Important. Always pull out the power plug
before doing any work on the circular saw!
Only use saw blades of the same type as the saw
blade supplied with this circular saw. Ask your dealer
for advice.
Important. The mini hand-held circular saw must not
be operated with the Allen key (11) inserted in it.
Remove the cover cap (8).
Press the spindle lock (9).
Undo the screw to secure the saw blade (a)
using the Allen key (11) clockwise.
Press the locking device for the safety hood (7),
push back the hinged guard hood and hold
firmly.
Remove the saw blade (12) in a downwards
direction.
Clean the flange and insert the new saw blade.
Pay attention to the running direction (see arrow
14
17.12.2009 13:56 Uhr Seite 14
on the housing (b) and saw blade).
Tighten the screw to secure the saw blade (a)
and check that it runs true.
Before you press the On/Off switch, make sure
that the saw blade is correctly fitted and that
moving parts run smoothly and the clamping
screws are tightened securely.
6.5 Overload cut-out (Figure 1)
The device is fitted with an overload cut-out. The
overload display (2) indicates the toolʼs operating
status.
The overload display (2) flashes: The tool is reaching
its load limit – reduce the feed speed.
The overload display (2) lights up continuously: The
tool is overloaded or blocked – the tool shuts down.
In this case, switch off and restart.
6.6 Line cuts (Fig. 7)
You can easily follow a drawn line with the help of
the indicators (a), which are fitted to the guard hood
at the front and rear.

7. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.