Storage And Transport; Repairs; Troubleshooting - Meister MFW300-1 Traduction Du Manuel D'utilisation Original

MW-5454300-Bediene-1602_(4) 18.02.16 09:36 Seite 56
3. Unlock the extraction duct (8) and
remove it from the multifunction tool
(see Fig. L).
4. Clean the extraction duct and the
power tool housing with a soft brush
or with compressed air.
5. In the case of heavy soiling wipe the
housing with a damp cloth.
6. Replace the extraction duct.
After every 8 operating hours
1. Undo and remove the extraction duct.
2. Oil the moving parts of the tool
holder (5) using ordinary all-purpose oil.
3. Replace the extraction duct.
10 – Storage and transport
NOTE: Risk of damage! Your
power tool can be damaged if it
is not properly stored or transported.
Store and transport the multifunction
tool in a clean, dry and frost-free
place. Always use the plastic case
supplied with the product for storage
and transport. Other methods of
storage and transport will not provide
sufficient protection.
• Make sure the multifunction tool and
attachments are completely dry.
• Roll up the power cable without
knotting or kinking it.
56
• Replace all the accessories including
the washer, Allen key and hex socket
screw back in the plastic case so they
do not get lost.
11 – Repairs
WARNING! Risk of electric
shock! There is an increased risk
of electric shock if you carry out your
own repairs or use unsuitable
replacement parts. Do not open the
tool housing. In the event of a defect,
repairs must be carried out by
authorised specialists. Please contact
the manufacturer via the service
department address shown on the
warranty certificate. This
multifunction tool contains electrical
and mechanical parts that are
essential for protection against
hazards.
• Do not attempt any repairs yourself!
• To prevent risks, a damaged power
cable must be replaced by the
manufacturer or by their customer
service representative.
12 – Troubleshooting
Many problems can be caused by minor
errors, which you can rectify yourself.
Follow the instructions contained in the
following table.
If the fault cannot be rectified please
contact Customer Service.