Installing The Dcs550 Pc Tools On Your Computer - ABB DCS550 Guide Rapide

Installing the DCS550 PC tools on Your computer

After inserting the DCS550 CD all programs and documenta-
tion necessary to work with the DCS550 will be automatically
installed.
This includes:
1. DriveWindow Light for parameterization, commissioning
and service
2. Hitachi FDT 2.2 for firmware download
3. Installation CD of DCS550 Drive for e.g. DWL Wizard,
ABB documents
Attention:
If You do not want to install a certain program just skip it by
using Cancel at the beginning of the program's wizard.
If the installation routine does not start automatically:
− Go to Start/Run and browse for setup.exe on the CD.
Now start the installation by confirming with OK
− Compact installation for DriveWindow Light + DCS550
add ons is reccomended
Steps to connect Drive to PC
− The documentation can be found under
C:\ABB\DCS550\Docu
− Remove design cover from the converter module
Remove the DCS550 Control Panel
if present. Depress the locks to
remove the cover
18 18
3ADW000395R0100 DCS550 Quick guide edisf a 3ADW000395R0100 DCS550 Quick guide edisf a
Connect drive (X34) to your
PC COM port
− Start DriveWindow Light PC tool
− Check the communication setting of your COM port
If You use ExpressCard to COM port interface or PCMCIA /
COM port double check the active COM enabled
Start => Settings => Control Panel => System => Hardware
=> Device Manager
− COM address of USB interface can change after the next
boot procedure or after disconnecting and reconnecting of
the USB interface.
Note:
ExpressCard / PCMCIA to COM port provide a stable and
faster drive interface.
Utilize DriveWindow Light or DCS550 Panel Wizard continue
with chapter Commissioning in this manual.