Transmit Mode - ASPERIUM Raptor Mode D'emploi

SETTINGS: TRANSMIT MODE
Before using the transmitter for the first time, you must transmit a mode to it. Two modes are preconfigured by default.
These can be adjusted at any time, as required.
To open the Mode 1 or Mode 2 dialogue box, proceed as follows:
1. Using button (1), move to the symbol (2) Settings.
2. Using the directional key (3), navigate to Transmit mode (4) and confirm by pressing OK (5).
3. Using the directional key (3), select Mode 1 / Mode 2 (6) and confirm by pressing OK (5).
(2)
(4)
(1)
(5)
(3)
16
(6)
ASPERIUM RAPTOR – USER MANUAL
The factory settings of Mode 1 and Mode 2 are explained below:
Mode 1: Message transmission – periodical
The transmitter sends its current position data every 6 minutes (1). While messages are being sent, the transmitter
flashes (flashing light activated = LED marked yellow (2)) for 10 seconds (3).
With the radius monitoring (4) activated, the transmitter compares its actual position with its starting point every
5 minutes (5). When the transmitter is moved beyond a 400-meter radius (6) from the starting point, message trans-
mission will commence. This function prevents messages being sent while the falcon is within your range of vision.
(1) Variable transmission intervals
from 6 mins to 150 mins
(2) LEDs for transmitter can
be switched on and off
(3) Duration of LED light, variable
from 10 secs to 20 secs
(1)
(4) Activate/deactivate radius
monitoring
(2)
(5) Variable radius monitoring
(3)
from 5 - 60 mins
(4)
(6) Variable radius from
(6)
400 meters to 2,000 meters
(5)
NOTE: Before each flight, please check the set values and adjust these if necessary.
In the next step, please transfer the mode to the transmitter
(8) (see section Transmitting the mode to the transmitter).
(7)
ASPERIUM RAPTOR – USER MANUAL
SETTINGS: TRANSMIT MODE
You can customise the mode
to your falcon's characteristics:
> Change each of the selection fields
by pressing OK.
> Using the directional key, change the number
value by pressing the up or down keys.
> Press SAVE (7) to confirm the new settings.
> Press FACTORY SETTINGS (8) to return to the
default values set by the manufacturer.
17