Transmitting The Mode To The Transmitter - ASPERIUM Raptor Mode D'emploi

SETTINGS: TRANSMIT MODE
Mode 2: Message transmission after a fixed time – 3 days x 8 messages
The transmitter sends its current position data at eight specified times (2) over three consecutive days (1). While
messages are being sent, the transmitter flashes (flashing light activated = LED marked yellow (3)) for 15 seconds (4).
With the radius monitoring (5) activated, the transmitter compares its actual position with its starting point every
5 minutes (6). When the transmitter is moved beyond a 400-meter radius (7) from the starting point, message trans-
mission will commence. This function prevents messages being sent while the falcon is within your range of vision.
(2) Setting transmission times
(3) LEDs can be switched on
and off during transmission
(4) Duration of LED light, variable
(1)
from 10 secs to 20 secs
(2)
(5) Activate/deactivate radius
(3)
monitoring
(6) Variable radius monitoring
from 5 - 60 mins
(4)
(7) Variable radius from
(5)
400 meters to 2,000 meters
(7)
(6)
NOTE: Before each flight, please check the set values and adjust these if necessary.
In the next step, please transfer the mode to the transmitter
(9) (see section Transmitting the mode to the transmitter).
(8)
18
You can customise the mode
to your falcon's characteristics:
> Change each of the selection fields
by pressing OK.
> Using the directional key, change the number
value by pressing the up or down keys.
> Press SAVE (8) to confirm the new settings.
> Press FACTORY SETTINGS (9) to return to the
default values set by the manufacturer.
> You can exit the table using the right
directional key, once you have confirmed the
LEDs by pressing OK.
ASPERIUM RAPTOR – USER MANUAL

TRANSMITTING THE MODE TO THE TRANSMITTER

To transmit the desired mode from the device to the transmitter, connect the handheld device
to the transmitter using the USB cable E (transparent).
In doing so, ensure that the red-marked connector (1) is plugged into the device and the connector (2)
is plugged into the transmitter.
(1)
E
NOTE: Once the transmitter is connected to the handheld device, it is charged by means of the handheld device batteries.
Please only connect the handheld device and the transmitter once both devices have been sufficiently charged!
ASPERIUM RAPTOR – USER MANUAL
(2)
19