Potential Faults With The Transmitter; Potential Faults With The Handheld Device - ASPERIUM Raptor Mode D'emploi

POTENTIAL FAULTS WITH THE TRANSMITTER

Fault Problem
When the transmitter is switched on, the The transmitter was unable to initialise
LEDs light up constantly. correctly via GPS.
You are in an enclosed space.
Trees or buildings are limiting your reception.
Transmitter does not respond during Battery has not been charged.
configuration with the handheld device. USB connection cable faulty.
No messages are arriving at the handheld There is no line-of-sight contact with the
device. Iridium satellite.
The battery charge is too low.
The GPS reception is too poor.
The transmitter and handheld device have not
been paired correctly.
The transmitter has not been activated correctly.
The transmitter will not switch on. The battery charge is too low or empty.
Incorrect position of the magnet switch on the
transmitter.
The magnet is too far away from the transmitter.
The transmitter will not switch off. Incorrect position of the magnet switch on the
transmitter.
The magnet is too far away from the transmitter.
The transmitter is currently in transmit mode.
34
Solution
Change your location.
Try to get a clear view of the sky.
Charge the battery.
Check the USB connection cable.
Change your location.
Recharge the battery.
Have the pairing checked by your satellite
service.
Charge the battery.
Check the position of the magnet.
Move the magnet closer to the transmitter.
Check the position of the magnet.
Move the magnet closer to the transmitter.
Attempt deactivation again after a few
seconds.
ASPERIUM RAPTOR – USER MANUAL

POTENTIAL FAULTS WITH THE HANDHELD DEVICE

Fault Problem
The handheld device screen is white, The handheld device battery is dead.
possibly with stripes. The battery contacts are not clean.
The polarity of the batteries / a battery has been
mixed up.
The handheld device is no longer The software has crashed.
responding to any key presses. This can occur in rare cases during the
interaction with the Sygic navigation software
used.
Message reception is not working. There are no messages on the Iridium server.
Satellite reception is poor.
The transmitter's IMEI number has not been
stored in your handheld device.
The satellite connection dropped due to poor
reception while the message was being
received.
The Set start point function does not work. No GPS reception.
ASPERIUM RAPTOR – USER MANUAL
Solution
Fully charge the batteries.
Check the battery contacts.
Check the +/- orientation of the batteries.
Only use Li ion batteries, Panasonic/Sanyo
3.7V, type UR14500P
Switch the device off, wait 10 seconds and
then switch it back on again.
Ensure that the transmitter is configured
correctly (transfer the Mode from the
handheld device via the USB cable) and
activated (magnetic contact).
Change your position in order to ensure a
clear view of the sky.
Connect the transmitter to your device using
the USB cable. The handheld device will
store the IMEI number automatically.
If no free spaces are available, you can
delete IMEI numbers that are no longer
required from your register.
The message currently arriving is
permanently lost.
Wait until the next message from the
transmitter and attempt reception again.
Ensure there is GPS reception by moving to
where there is a clear view of the sky.
35