Deactivating The Transmitter; Fitting / Removing The Transmitter To / From The Backpack System - ASPERIUM Raptor Mode D'emploi

DEACTIVATING THE TRANSMITTER

Hold the magnetic switch (2) installed in the transmitter against the magnet (1) located in the handheld device
for approx. 4 seconds.
(1) The transmitter flashes rapidly for approx. 6 seconds and then stops.
The transmitter is now deactivated!
NOTE: If the transmitter is currently in the process of transmitting, it cannot be
deactivated. In this case, repeat the deactivation procedure after a few seconds.
22
(2)
ASPERIUM RAPTOR – USER MANUAL

FITTING / REMOVING THE TRANSMITTER TO / FROM THE BACKPACK SYSTEM

Fitting the transmitter:
Pull the locking bar (1) approximately 10 mm out of the housing so that the mounting recess (2) on the underside of the
transmitter is completely open.
Place the transmitter with the mounting recess (2) on the eyelet of the holding plate (3) in the backpack system and slide
the locking bar (1) forwards again until it engages.
NOTE: Ensure that the backpack system is fitted correctly on the falcon. Also note the manufacturer's instructions.
Ensure that the transmitter is correctly and tightly locked to the holding plate and also check the transmitter's position
on the falcon.
10 mm
(2)
(2) (1)
(3)
Removing the transmitter:
To remove the transmitter from the falcon, hold the transmitter firmly with one hand and with the other pull
the locking bar (1) backwards (approx. 10 mm) until the transmitter is released from the holding plate (3).
ASPERIUM RAPTOR – USER MANUAL 23