Operation - Heatsail DISC CANTILEVER Manuel

EN
7.

Operation

Activate your DISC
After the DISC is wired to a suitable power outlet, the DISC may be
powered on. The right switch (marked LOW - 0 - HIGH) switches the
heater on. On "LOW" only three side elements provide heat. On "HIGH"
all five side elements and the round bottom element are providing
heat. "0" switches the heater off. When you switch on the DISC, it
takes up to 30 minutes before the DISC reaches its full temperature.
When switched off, it may take up to 40 minutes before the DISC has
completely cooled down.
The left switch (marked DIM - 0 - ON) manually controls the light.
"DIM" ENABLES THE REMOTE
Enable the light with remote
"O" LIGHT OFF
Switch off the light without the remote
"ON" LIGHT ON
Switch on the light without the remote
26
Light off
Brightness down*
50% Brightness
H1
No function
OFF
H2
No function
OFF
Top view
Light on
Brightness up*
100% Brightness
H1
No function
ON
H2
No function
ON
*Hold down these buttons.
Front side
LOW
DIM
0
0
HIGH
ON
Located on the back
of the panel of the
base of the DISC.
Heatsail DISC® CANTILEVER