Replacing The Bulb - Heatsail DISC CANTILEVER Manuel

EN

3.2. Replacing the bulb

Your DISC is supplied with a R7S 240V/120 Watt (78mm) halogen bulb as
standard. The maximum permitted output power of the bulb is 120 Watt.
The electrical supply must be disconnected via the installation's breaker
switch before the bulb can be replaced.
You can replace the bulb by removing the 2 half rings and pulling the glass
of the DISC downwards. The bulb is held in place by a spring. Remove the
bulb by first pushing it to the left or right and thereby releasing it from its
socket. Then replace the bulb and reverse previous steps.
Please note: Be careful never to touch the halogen bulb with bare fingers,
as oils from skin will significantly reduce bulb life.
3.3. Inspection
The DISC must be subjected to an annual inspection.
The user is not authorized to carry out his own inspections and repairs.
Inspection of the DISC must exclusively be carried out by qualified and
authorized technicians, in accordance with Heatsail's applicable standards
and regulations. "Qualified technicians" are understood to mean: qualified
electricians who are familiar with the applicable electrical laws and
regulations in accordance with the requirements of NFPA 70 and OSHA
Regulations 29 CFR 1910.304(b)(2).
The electrical supply must be disconnected via the installation's main
breaker or by disconnecting the plug before any work can be carried out.
All repairs must be requested via an authorized distributor of Heatsail
products. A repair is only valid when original parts have been used.
Upon written approval by Heatsail, the entire control panel should be
returned in case of a defective cable.
Heatsail will not be held responsible for damage resulting from
non-compliance with the maintenance instructions.
Manual 9