Heatsail DISC CANTILEVER Manuel page 21

S T E P 1 9
Insert the wires
corresponding terminals:
Wire Wire
number color
1 BLACK
2 GRAY
3 BROWN
4 BLUE
5 GREEN/
YELLOW
Push down on terminal with screwdriver tip (as shown above) while inserting the
To Dome
wire into the terminal to release terminal tension. Once wire is fully seated, release
terminal and the wire will be held in place.
To Dome
Test connection by gently tugging on wire. A well-seated wire will not easily pull out.
You can find the wiring diagram on page 29.
S T E P 2 0
Using the
screwdriver, reaffix
cover of the control box with the
four screws.
Manual
into the
Pictogram
Phillips-head
the rear
5 4 3 2
1
EN
21