Heatsail DISC CANTILEVER Manuel page 20

EN
S T E P 1 7 a
Affix the DISC using three
of the M6 set screws.
NOTE: Use the black or gray set
screws depending on the color of
your DISC.
S T E P 1 7 b
Insert the remaining M6 set screw
to adjust the tilt of the DISC.
S T E P 1 8
Remove the rear cover from the
control box.
Insert the cable through the
cable guide on the rear cover of
the control box.
Ensure the other wires within the
control box are not disconnected
during this process.
20 Heatsail DISC® CANTILEVER