Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.
Operation
Activate your BEEM
When you switch on the BEEM, it takes up to 30 minutes before the
BEEM reaches its full temperature. When switched off, it may take
up to 40 minutes before the BEEM has completely cooled down. To activate
your BEEM, use the wall switches installed by your certified electrician.
8.
Troubleshooting
The electrical supply must be disconnected via the installation's main
breaker before any work can be carried out.
The light does not work
You can replace the bulb by carefully lifting up the glass panel and remove
it by turning it. Now you have access to the halogen bulb. Verify it is well
inserted and not broken. If you need to change the bulb, replace it with a
standard G9 halogen bulb of 120V/ MAX40 Watt.
NOTE: Always use a cloth or gloves to replace the bulb, as touching it with
bare fingers shortens the bulb life considerably.
If this does not resolve your issue, verify that the brown wires are properly
inserted into the connection block (Step 10).
No heat
Check if the BEEM is switched on.
Check if wires 1 to 4 are connected properly (Step 10).
Only some elements are heating
If elements are not working, verify that wires 1 and 2 or 3 and 4 are
connected properly (Step 10).
Nothing works
Verify that the circuit breaker switch is not tripped/is turned on.
Manual
EN
21
Publicité
Table des Matières
Dépannage
