Product Rating Label - Husqvarna ROYAL 49S Mode D'emploi

B
Product Number . . . . . . . . . . . . . . . . . .
Model Number . . . . . . . . . . . . . . . . . . .
Serial Number. . . . . . . . . . . . . . . . . . . .
Date of Purchase . . . . . . . . . . . . . . . . .
Place of Purchase. . . . . . . . . . . . . . . . .
•PLEASE KEEP PROOF OF PURCHASE•
Handle Assembly
1. Your product is supplied
with the handles folded
over the product. (C1)
2. Loosen handle
adjusters (C2) on both
sides of the product
and lift handle
assembly up.
3. Adjust handle assembly
to the most comfortable
operating position (C3)
and tighten handle
adjusters (C2) on both
sides of the product
Recoil Starter
1. Disconnect the spark
plug lead.
2. Pull the Operator
Presence Control (D1)
to release the brake on
the engine.
ROYAL 49S AND
ROYAL 49SE ONLY
You must release the
brake by pulling the
OPC lever to the
handle before pulling
out the cord.
English - 3

PRODUCT RATING LABEL

ASSEMBLY INSTRUCTIONS
C1
C2
handle
adjuster
C3
D1
Please Note :- Ensure no gap remains between the safety flap and the
grassbox
Where grass collection is not required you can use the lawnmower
without the grassbox. Ensure the safety flap is fully closed
Your product is uniquely identified by a silver
and black product rating label. To ensure you
have full product information when obtaining
spares or advice from one of our approved
service centres or if you need to contact our
customer service department you should make
a note in the space provided of the information
shown in Fig B
3. Locate cord in the pull
cord guide on the lower
handle. (D2)
ROYAL 49S AND
ROYAL 49S/BBC
ONLY
4. Locate cord in the pull
cord guide on the
upper handle. (D3)
Fitting the Grassbox
1.Lift safety flap. (E1)
2. Locate grassbox to
machine. (E2)
3. Locate safety flap onto
the top of the grassbox.
(E3). Ensure the
grassbox is securely
located.
E2
D2
D3
E1
E3