Husqvarna ROYAL 49S Mode D'emploi page 10

Starting & Stopping Royal 49S
Starting
1. Connect the spark plug
lead.
2. Move the Engine
Speed Control to the
FAST '+' position
before starting. (J1)
3. Pull the operator
presence control (OPC)
to release the brake on
the engine and the
blade.(J2)
4. Pull the recoil starter
fully towards you until
you feel the full
resistance, return the
handle slowly then pull
the handle firmly
towards you to its full
extent. (J3)
5. After the engine has
started, allow to run for
30 seconds before
commencing to use.
Engaging the Drive
1. Forward drive is
engaged and
disengaged with the
Powerdrive lever at the
top of the handle (J4).
2. Drive speed can be
altered with the drive
speed control. (J5)
3. Releasing the
Powerdrive Lever stops
the forward drive
automatically.
Stopping
1. Release the
powerdrive lever.
2. Release the OPC
lever.
English - 5
USE - STARTING AND STOPPING
J1
-
+
J2
J3
recoil starter
J4
J5
drive speed
control
engine speed
control
Starting & Stopping Royal 49SE
Starting
1. Follow steps 1-3 for the
Royal 49S
2. Turn the key and hold
until the engine starts
(K1). The key will
return to the original
position when
released.
3. If the engine fails to
start when you turn the
key your battery may need charging.
Please note:- Your Royal 49SE can be started
manually by following steps 1-5 in
Starting & Stopping Royal 49S
Key Start Only - During mowing, your engine
will recharge the battery
Engaging the Drive - See Royal 49S
Stopping - See Royal 49S
Starting & Stopping Royal 49S/BBC
(BBC - Blade, Brake , Clutch)
1. Follow steps 1 - 2 - 4 and 5 for the Royal
49S.
2. Pull the BBC arm to the handle (L1).
3. While holding the BBC
arm, push forward BBC
control lever until a
click is heard (L2).
4. Release the BBC
control lever which will
return to its original
position.
5. Releasing the BBC arm
will stop the blade from
rotating.
Please Note:
Leaving the engine
running without the
blade rotating for an
extended length of time
could lead to the engine
overheating.
Engaging the Drive - See Royal 49S
Stopping
1. Release the powerdrive lever.
2. Release the BBC arm.
3. Move Engine Speed Control to the '-'
position.
K1
L1
L2