EINHELL KH 1500/1 Instructions D'origine page 17

10. Troubleshooting
If the equipment is operated properly you should experience no problems with malfunctions or faults.
In the event of any malfunctions or faults, please check the following before you contact your customer
services.
Fault
Equipment does not
work
Anl_KH_1500_1_SPK9.indb 17 Anl_KH_1500_1_SPK9.indb 17
GB
Possible cause
Power plug is not connected
The topple cut-out has triggered
The thermostat control is set too low
Overheating guard has been triggered
Switch "I" is not switched on
- 17 -
Remedy
Connect the power plug
Place the machine on a level surface
Turn the thermostat control to the
right, to a higher temperature
Please note section 6.4
Switch on switch "I"
14.11.2018 10:21:11 14.11.2018 10:21:11