Dremel 3D45 Traduction De La Notice Originale page 622

BEFORE YOU BUILD
1. Ensure an adequate amount of filament is loaded
(see page 615). If 3D45 runs out of filament
during a build, it will pause until more filament is
added.
2. Ensure glue is applied, build platform is level and
clear of objects.
3. Ensure the extruder and build platform temperature
is set according to the filament type used, see
page 617 for details.
BUILDING FROM ON-PRINTER STORAGE
1. On the main menu tap "Build".
2. On the build menu tap the printer icon.
3. Tap the model file you would like to build.
(Use arrows to scroll through pages)
4. In the model detail page tap "Build" to begin
building process.
5. Your 3D45 will first align the extruder and build
platform to their zero positions then the level
sensor will lightly touch the build platform to
complete alignment. Your extruder tip and build
platform will begin to heat which may take a few
minutes. Once the proper temperature is reached
your model will begin to build.
6. Once your object is finished your 3D45 will
automatically align the extruder and build platform
to their calibration positions and cool the extruder
tip and build platform.
7. Wait until the touch screen indicates that the
extruder and build platform are "cool" to remove
your object. See section "Removing Object from
Build Platform" for object removal instructions.
622