Dremel 3D45 Traduction De La Notice Originale page 24

GETTING READY TO BUILD
FIG. 3
Tab
Front Clip
PREPARING BUILD PLATFORM
DO NOT TOUCH THE EXTRUDER
WARNING
!
TIP OR HEATED BUILD
PLATFORM DURING DREMEL 3D45 OPERATION OR
UNTIL IT HAS COOLED DOWN TO AT LEAST 60°C
(140°F). Contact with the extruder tip or build
platform during or after operation before tip and build
platform has cooled may result in personal injury.
DO NOT DROP THE BUILD
WARNING
!
PLATFORM. Tempered glass plate
may break and result in personal injury.
DO NOT REMOVE TEMPERED
WARNING
!
GLASS PLATE FROM PLASTIC
HOLDER. Contacting with tempered glass plate edge
may result in personal injury.
BEFORE EVERY BUILD MAKE
!
SURE THAT THE BUILD
PLATFORM IS COVERED WITH GLUE FROM THE
SUPPLIED GLUE STICK. If glue is not used, it may
cause poor object build quality.
1. Remove build platform by first pressing down and
releasing the two clips located at the front of the
build platform, then lift the build platform off the
base using the build platform tabs (figure 3).
Rear Clip
Base Build Platform
2. For best results, apply a thin layer of glue with the
FIG. 4
3. Install the build platform by first inserting the rear
24
Rear Clip
Front Clip
provided glue stick to the build platform, figure 4.
Please check the "Glue Application Instructions" for
detailed information.
Glue stick
NOTE: To clean the build platform, rinse the
platform with warm water and dry with a towel.
of the platform onto the rear clips, then press down
on the front of the platform until it snaps in place.
Tab