Dremel 3D45 Traduction De La Notice Originale page 33

UPDATING FIRMWARE MANUALLY
If your 3D45 is not connected to a network, you can
update firmware directly from a USB Flashdrive.
1. On your web browser go to www.dremel3d.com
and download the latest 3D45 firmware file.
2. Add the 3D45 firmware file to an empty, FAT32
formatted, USB flashdrive.
3. Turn off your 3D45 using the ON/OFF switch.
4. Insert the USB flashdrive into the USB-A port.
5. Turn on your 3D45 and it should automatically
detect and install the new firmware.
6. Turn your 3D45 OFF, remove the USB flashdrive,
and turn ON again to complete the update.
CLEANING THE EXTERIOR
Clean the 3D45's exterior with a lint free cloth. Clear
the outer surfaces of any debris that is visible.
To avoid damaging your Dremel 3D45 do not use
water, chemicals or other cleaners on the 3D45.
CLEANING THE EXTRUDER TIP
USE EXTRA CARE NOT TO
!
DAMAGE THE EXTRUDER TIP
WHEN CLEARING DEBRIS. DREMEL 3D45 WILL NOT
WORK PROPERLY WITH DAMAGED EXTRUDER TIP
AND WILL REQUIRE REPLACEMENT.
DO NOT TOUCH THE EXTRUDER
WARNING
!
TIP OR HEATED BUILD
PLATFORM DURING DREMEL 3D45 OPERATION OR
UNTIL IT HAS COOLED DOWN TO AT LEAST 60°C
(140°F). Contact with the extruder tip or build
platform during or after operation before tip and build
plate has cooled may result in personal injury.
Using small needle nose pliers, pull away any plastic
debris from the extruder tip.
If the debris is stubborn, the extruder may need to be
heated.
CLEANING THE TOUCH SCREEN
Wipe the touch screen with the soft, lint-free cloth. Do
not spray cleaners on the touch screen.
33