Dremel 3D45 Traduction De La Notice Originale page 620

LEVELING BUILD PLATFORM
DO NOT TOUCH THE EXTRUDER
WARNING
!
TIP OR HEATED BUILD
PLATFORM DURING DREMEL 3D45 OPERATION OR
UNTIL IT HAS COOLED DOWN TO AT LEAST 60°C
(140°F). Contact with the extruder tip or build
platform during or after operation before tip and build
plate has cooled may result in personal injury.
It is important you level the build platform every time
you reinstall the build platform to ensure that the build
platform is evenly spaced from the extruder head. Not
leveling the build platform may cause objects to not
build properly.
1. Tap "Level" on 3D45's touchscreen.
2. The extruder and build platform will move into
position to level the build platform. 3D45 will first
check level at the back center of the build platform.
The two knobs under the build platform are used
to raise and lower the build platform on the left and
right. The extruder contains a sensor that detects if
the bed is level, no additional tools are necessary.
3. The touchscreen will indicate if your build platform
is too high or too low. If the build platform is too
high, adjust the appropriate knob by rotating right
until you hear a "beep" and the touchscreen
indicates that it is ready to verify that the bed is
level.
4. If the build platform is too low, adjust the knob by
rotating left until you hear a "beep" and the
touchscreen indicates that it is ready to verify that
the bed is level.
5. Tap "Verify" to check the bed level. If further
adjustment is needed the touchscreen will indicate
the direction, if the level is correct, the extruder will
move to the next point and the level process can
be repeated.
6. Repeat steps 3-5 for the second position, when the
bed is fully level the extruder will automatically
move to the calibration position and complete the
leveling process.
620