Publicité
Les langues disponibles
Les langues disponibles
LOGIC ADJUSTMENTS DIP-SWITCHES
N°1
DISABLES AUTOMATIC RE-CLOSING:
OFF: the automatic closing after opening is disabled.
ON: automatic timer-controlled re-closing enabled (adjustable with the trimmer T.C.A.).
N°2
2- OR 4- STAGE OPERATION:
ON: with the automation enabled, a series of opening and closing commands
induces the shutter to perform an OPENING-CLOSING-OPENING-CLOSING type
of sequence.
OFF: in the same conditions, the same set of commands induces the shutter to
perform an OPENING STOPPING-CLOSING-STOPPING-OPENING-STOPPING
type of cycle (step-by-step operation)
N°3
NO REVERSE:
OFF: during opening the automation ignores any closing commands.
ON: the automation's behavior depends on the position of dip switch 2.
N°4
TIMER FUNCTION:
OFF: a timer (e.g. weekly) can be connected to the input for the open/close button
to have the gate open at certain times of day and enable its subsequent automatic
closing again.
ON: the input for the open/close button continues to function normally.
N°5
PREFLASHING ON/OFF OPTION:
OFF: flashing begins when the automation is enabled.
ON: flashing begins a few seconds before the automation is enabled.
POWER CONTROL
The power is adjusted by means of a control with four positions, ranging from 1 (minimum
power) to 4 maximum power. This device is used to adjust the force of the operator directly
from the control unit.
DIAGNOSTIC LEDS
The green leds indicate the presence of normally-closed contacts, so they will always remain
on if there are no problems in the system. The red leds, on the other hand, indicate normally-
open contacts so they only come on if they are in use (with the exception of led 1 which
remains on to indicate that the circuit is powered).
LED RED
L1= indicates the presence of the power supply 24
LED GREEN
L2= Indicates the enabling of the input for the CLOSING LIMIT SWITCH
LED GREEN
L3= Indicates the enabling of the input for the OPENING LIMIT SWITCH
LED GREEN
L4= Indicates the enabling of the STOP command
LED GREEN
L5= Indicates the enabling of the input for the PRESSURE-SENSITIVE EDGE
LED RED
L6=indicates the enabling of the OPEN/CLOSE command
11
Publicité
