Table Des Matières - Nice mindyA500 Instructions Pour L'installation

mindy A500
Index:
1 Description of the product
2 Installation instructions
2.1 Input voltage selection
2.2 Wiring diagram
2.3 Description of connections
2.4 Notes about connections
3 Testing
4 Adjustments
5 Obstacle adjustment system
Introduction:
This manual has been especially written for use by technical personnel
qualified to carry out installation. No information given in this manual can
be considered as being of interest to end users! This manual is enclosed
with control unit A500 and may not be used for different products!
Important notice:
The A500 control unit has been designed to control an electromechanical
actuator for automating gates or doors. Any other use is considered
improper and is consequently forbidden by current laws.
May we remind you that the automation system you are about to
install is classified as "building a machine" and therefore enters the field of
application of European directive 89/392 EEC (machine directive).
This directive includes the following prescriptions:
-Only trained and qualified personnel should install the equipment
-The installer must first perform the "risk analysis" of the machine
-The equipment must be correctly and professionally installed in
compliance with all relevant standards.
-After installation, the machine owner must be issued with the
"declaration of conformity".
4
6 Operating modes
7 Programming
7.1 Programmable functions
7.2 Description of functions
8 Using 2 central units on opposite wings
9 Accessories
10 Maintenance
10.1 Environmental protection measures
10.2 Technical specifications
This product may only be installed and serviced by qualified personnel,
therefore, in compliance with current laws, standards or directives.
When designing and producing its products, Nice observes all applicable
standards (please see the attached declaration of conformity) but it is of
paramount importance that installers continue to strictly observe the
same standards when installing the system.
Unqualified personnel or those who are unaware of the standards
!
applicable to the "automatic gates and doors" category may not install
systems under any circumstances
Whoever ignores such standards will be held responsible for any
!
damage caused by the system!
Do not install the unit before you have read all the instructions
!
thoroughly!