Setting Mode - AEG FAVORIT 88065 VI Mode D'emploi

USING THE DETERGENT
A B
30
20
SETTING AND STARTING A
PROGRAMME

Setting mode

The appliance must be in setting mode
to accept some operations.
The appliance is in setting mode when,
after the activation:
• The display shows two horizontal sta-
tus bars.
If the control panel shows other condi-
tions, press RESET until the appliance is
in setting mode.
Starting a programme without
delay start
1. Open the water tap.
1. Press the release button (B) to
A
+ -
2. Put the detergent in the compart-
3. If the programme has a prewash
C
4. If you use detergent tablets, put
5. Close the lid. Make sure that the
2. Press the on/off button to activate
3. Set the programme.
4. If you want, you can set the options.
5. Close the appliance door. The pro-
Starting a programme with
delay start
1. Set the programme.
CAUTION!
Use only detergents for dish-
washers.
open the lid (C).
ment (A) .
phase, put a small quantity of de-
tergent on the inner part of the ap-
pliance door.
the tablet in the compartment (A).
release button locks into position.
Do not use more than the cor-
rect quantity of detergent. Refer
to the instructions on the deter-
gent packaging.
Detergent tablets do not fully
dissolve with short programmes
and detergent residues can stay
on the dishes.
We recommend that you use
detergent tablets with long pro-
grammes.
the appliance. Make sure that the
appliance is in setting mode.
• The related programme number
flashes in the display.
gramme starts.
• The display goes off. If you open
the door while the appliance op-
erates, the display shows the pro-
gramme duration that decreases
with steps of 1 minute.
ENGLISH
37