Setting Mode - AEG FAVORIT 55420 Notice D'utilisation

SETTING AND STARTING A
PROGRAMME

Setting mode

The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when,
after the activation:
• All the phase indicators come on.
• The time of the last set programme
flashes in the display.
If the control panel shows other condi-
tions, press and hold Multitab and Delay
at the same time until the appliance is in
setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate the
appliance.
3. Close the appliance door.
4. Make sure that the appliance is in set-
ting mode.
5. Turn the programme knob until the
marker on the knob is aligned with the
programme you want to set.
• The programme duration flashes in
the display.
• The phase indicators of the set pro-
gramme come on.
6. Press Start. The programme starts.
• Only the indicator of the phase in
operation stays on.
• The display shows the programme
duration that decreases with steps
of 1 minute.
Starting a programme with
delay start
1. Set the programme.
2. Press Delay again and again until the
display shows the delay time you want
to set (from 1 to 24 hours).
• The delay time flashes in the dis-
play.
3. Press Start. The countdown starts.
• The display shows the countdown of
the delay start that decreases with
steps of 1 hour.
• The phase indicators of the set pro-
gramme go off.
• When the countdown is completed, the
programme starts.
– The indicator of the phase in opera-
tion comes on.
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while
the countdown operates
Press Delay again and again until:
• The display shows the programme du-
ration.
• The phase indicators come on.
• The programme starts.
Cancelling the programme
Press and hold Multitab and Delay at the
same time until:
• The programme duration flashes in the
display.
• The phase indicators come on.
Make sure that there is detergent
in the detergent dispenser before
you start a new programme.
At the end of the programme
When the programme is completed, the
phase indicators are off and the display
shows 0.
1. Open the appliance door.
2. Press the on/off button to deactivate
the appliance.
3. Close the water tap.
If you do not press the on/off but-
ton, the Auto Off device auto-
matically deactivates the appli-
ance after some minutes. This
helps to decrease the energy con-
sumption.
• For better drying results, keep the ap-
pliance door ajar for some minutes.
ENGLISH
35