tau SOFT-START BIG40Q Mode D'emploi page 13

MANUFACTURER'S DECLARATION OF INCORPORATION
(in accordance with European Directive 2006/42/EC App. II.B)
Manufacturer:
Address:
Declares under its sole responsibility, that the product:
designed for automatic movement of:
for use in a:
complete with:
Model:
Type:
Serial number:
Commercial name:
Has been produced for incorporation on an access point (sliding gate) of for assembly with other devices used to
move such an access point, to constitute a machine in accordance with the Machinery Directive 2006/42/EC.
Also declares that this product complies with the essential safety requirements of the following EEC directives:
- 2006/95/EC Low Voltage Directive
- 2004/108/EC Electromagnetic Compatibility Directive
and, where required, with the Directive:
- 1999/5/CE Radio equipment and telecommunications terminal equipment
Also declares that it is not permitted to start up the machine until the machine in which it is incorporated or of
which it will be a component has been identified with the relative declaration of conformity with the provisions of
Directive 2006/42/EC.
The manufacturer undertakes to provide, on sufficiently motivated request by national authorities, all information
pertinent to the quasi-machinery.
Sandrigo, 31/03/2010
Name and address of person authorised to draw up all pertinent technical documentation:
Loris Virgilio Danieli - via E. Fermi, 43 - 36066 Sandrigo (Vi) Italy
Electronic control unit
Sliding Gates
Industrial
-
SOFT-START
SOFT-START
see silver label
Control panel for 400 Vac three-phase motor
Legal Representative
_________________________________________
SOFT-STARTER
TAU S.r.l.
Via E. Fermi, 43
36066 Sandrigo (Vi)
ITALY
Bruno Danieli
13