EMAK efco MT 2200 Mode D'emploi page 40

I
WARNING: always stop the tool and remove the battery before carrying out any of the
corrective checks recommended in the table below, except when they require the tool
to be operational.
GB
When you have checked all the possible causes listed and you are still experiencing the problem,
see your Servicing Dealer. If you are experiencing a problem that is not listed in this chart, see your
Servicing Dealer for service.
PROBLEM
F
The motor doesn't start or
runs unevenly.
D
E
Engine does not reach full
speed.
SK
Bar and Chain Running Hot
and Smoking
P
GR
TR
CZ
Engine starts and runs, but
chain is not rotating
RUS
UK
WARNING: Never
touch the chain
while the engine
PL
is running.
WARNING! Also read the battery and battery charger instruction and maintenance
manual!
36
13. TROUBLESHOOTING
POSSIBLE CAUSE
1. Battery drained or
fitted incorrectly
2. Motor damaged
3. Damaged battery
Chain too taut
1. Chain oil tank empty.
2. Chain too taut
3. Oiler function.
1. Chain too taut
3. Bar and chain assembly
incorrect
4. Chain and/or guide bar
damaged.
5. Rim sprocket damaged.
SOLUTION
1. Charge the battery or fit it correctly
2. Replace: contact an Authorised Service
Centre
3. Replace: contact an Authorised Service
Centre
Te n s i o n c h a i n p e r i n s t r u c t i o n s i n
Operation-Chain Tension section (Pag.26).
1. Top up the oil reservoir.
2. Tension chain per instructions in
Operation- Chain Tension sec tion
(Pag.26).
3. Run at full throttle 15 to 30 seconds.
Stop saw and check for oil dripping
from bar tip guard and guide bar. If oil is
present the chain may be dull or bar
may be damaged. If no oil contact a
Servicing Dealer.
1. Tension chain per instructions in
Operation- Chain Tension sec tion
(Pag.26).
3. Refer to Assembly-Assembling the Bar
and Chain Section (Pag.26).
4. Refer to Maintenance-Chain and/or
M a i n t e n a n c e - G u i d e B a r S e c t i o n
(Pag.31).
5. Replace: contact an Authorised Service
Centre.