OPERATION
5. After connecting cables to bottom battery, carefully
hang metal battery tray on studs located above
bottom battery. Place top battery into tray with
posts positioned towards rear of machine. Secure
top battery with strap (Figure 3).
FIG. 3
6. Connect black battery cable coming from machine
to negative (--) post of top battery. Then connect
opposite end of black jumper cable to positive (+)
post (Figure 4).
(- - )
Black
Cable
(- - )
Jumper
Cable
FIG. 4
7. Reconnect vacuum hose to recovery tank snout
as shown (Figure 5).
FIG. 5
8
(+)
Jumper
Cable
TOP
BATTERY
(+)
Red Cable
BOTTOM
BATTERY
Home
Find... Go To..
8. After batteries are properly installed, turn on key
and vacuum switch and check battery meter
charge level. Charge if necessary (See BATTERY
CHARGING) (Figure 6).
FIG. 6
MACHINE SETUP
ATTACHING SQUEEGEE ASSEMBLY
1. Turn key to the off position.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.
2. Raise squeegee mount bracket by moving
squeegee lift knob to the left (Figure 7).
FIG. 7
3. Loosen two thumb knobs on squeegee assembly
and slide squeegee into slots on squeegee mount
bracket (Figure 8).
Speed Scrub 1701 Plus (02- -04)