Dimmer Control - LEXIBOOK HPl500 Manuel D'instructions

DIMMER CONTROL

The display dimmer control was set to the High position at our factory.
If you find the display to be too bright for sleeping, slide the Dimmer switch to
the Low position.
Auxiliary Input Jack
This system includes an Auxiliary Input Jack on the back panel so that you can
connect older non-dockable iPods®, other MP3 players, or personal CD
players, and listen to them through the speakers of this system. Use a mini
stereo connection cable, not included, to connect the headphone jack of your
external unit to the Aux In jack on the back panel of this system. Press the
Function button on the top panel or remote control of this system to select the
AUX function. The Aux indicator appears in the display. Set the Volume level
control on this system to a medium level (approximately "30" on the volume
level display).
Operate your external device as usual. Make final adjustments to the volume
controls of this system and to your external device to achieve the desired
level. Keep in mind that if the volume level of this system is set too low and the
volume level of your external device is set too high the sound may be distorted.
You need to experiment with both volume controls to find the most desirable
volume level settings.
Mute Control (Remote Control Only)
If you need to shut off the speakers of this system temporarily press the Mute
button on the remote control.
The sound stops and the MUTE indicator appears in the display. To cancel the
Mute function and restore the sound, press the Mute button again or press the
Volume + or – buttons. The MUTE indicator disappears.
67
HPI500FR-GBIM0236.indd 67 09/06/2006 16:38:37