LEXIBOOK HPl500 Manuel D'instructions page 50

To manually adjust the time display depress and hold the Time button, and
press either the Tuning/Skip (Clock/Time) or buttons to adjust the time
display ahead or back as desired. Each press of the Tuning/Skip (Clock/Time)
or buttons will change the display by one minute.
If you hold the Tuning/Skip (Clock/Time) or buttons the display will
continue to change. The display will change slowly at first, one minute at a time.
But if you continue holding the Tuning/Skip (Clock/Time) or buttons the
display will change rapidly.
NOTE: If you manually adjust the time, your new setting is entered into the
SmartSet® memory. If the power is interrupted, the display will return to your
new setting, not the original setting, when the power is restored.
Adjusting the Wake Up Times
Your SmartSet® clock radio has two separate alarms that can be set and used
independently. You may use the alarms to wake two people at different times,
or you may use one alarm for weekdays and the other for weekend wake up
times. The procedure for adjusting the wake up time is the same for both Alarm
1 and Alarm 2.
1.) Depress and hold either the Alarm 1 or Alarm 2 setting button. The display
will change from the correct time to the Alarm 1 or Alarm 2 wake up time.
2.) While holding the Alarm 1 or Alarm 2 setting button, depress either the
Tuning/ Skip (Clock/Time) or buttons to move the display ahead or back
to your desired wake up time.
3.) When the desired wake up time appears on the display, release the Tuning/
Skip (Clock/Time) or buttons.
NOTE: Be sure that you have set the wake up time correctly by observing the
AM indicator. If the AM indicator is 'On'the wake up time is "AM". If the AM
indicator is 'Off', the wake up time is "PM".
4.) When the desired wake up time (AM or PM) appears on the display, release
the Alarm 1 or Alarm 2 setting buttons.
50
HPI500FR-GBIM0236.indd 50 09/06/2006 16:38:18