Sleep Timer - LEXIBOOK HPl500 Manuel D'instructions

When the snooze function has been activated the appropriate AL 1 or AL 2
indicator flashes in the display.
NOTE: The Snooze Sensor detects the difference in temperature between your
hand and the ambient temperature. However in the unusual condition where
there is almost no difference between your hand temperature and the room
temperature the Touchless snooze function may no operate. In this case, please
press the SNOOZE button on the panel or use the remote control.

SLEEP TIMER

The Sleep Timer allows you to operate the radio or iPod® for up to 99 minutes
while you are falling asleep and then shuts the power off automatically.
1.) Turn the system 'On' and operate the radio or iPod® as usual.
Adjust the Volume control to the desired level for falling asleep, but remember
that the level you set for falling asleep is that same level that you will hear in the
morning if you are waking to radio or iPod®.
2.) Press the Sleep button on the top panel. The display will briefly show "L:30"
and the SLP (Sleep) indicator will appear.
The radio or iPod® will operate for 30 minutes and then shut off automatically.
3.) To change the amount of Sleep time depress and hold the Sleep button and
press the Tuning/Skip or buttons on the top panel or the / buttons
on the remote control to decrease or increase the amount of sleep time from
"01" minutes to "99" minutes.
NOTE: When you change the Sleep timer from the original 30-minute default
setting your new setting becomes the new default setting. For example if you
change the Sleep timer setting from 30 minutes to 45 minutes, 45 minutes
65
HPI500FR-GBIM0236.indd 65 09/06/2006 16:38:37