Installing The Remote Control Batteries - LEXIBOOK HPl500 Manuel D'instructions

INSTALLING THE REMOTE CONTROL BATTERIES

The remote control requires two "AAA UM-4" batteries, not included. We
recommend that you use a well known brand batteries for longest life and best
performance.
Open the remote control battery compartment by sliding the battery
compartment cover in the direction of the 'arrow'.
Install two "AAA UM-4" batteries in the compartment according to the polarity
markings inside the compartment as shown in the illustration. If the batteries are
installed incorrectly, the remote control will not work. After installing the batteries
replace the battery compartment cover.
Note: When the operation of the remote control becomes intermitted or stops
working completely replace the batteries as soon as possible. Never leave weak
or exhausted batteries in the remote for an extended period of time. They may
eventually leak and cause permanent damage to the remote control.
Battery Precautions
• Replacement of batteries must be done by an adult.
• Do not mix old and new batteries.
• Do not mix alkaline (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
• The supply terminals are not to be short-circuited.
• Non-rechargeable batteries are not to be recharged.
• Exhausted batteries are to be removed.
• Only batteries of the equivalent type are to be used.
• Dispose of batteries properly. Do not dispose of batteries in the fire. The
batteries may explode or leak.
47
HPI500FR-GBIM0236.indd 47 09/06/2006 16:38:07