LEXIBOOK HPl500 Manuel D'instructions page 58

Important iPod nano instructions!
If you are using this system with an iPod nano will notice that the iPod 30-pin
connector on this unit is not properly aligned with the opening in the ipod nano
adapter. Before inserting the iPod nano adapter into the docking area you must
slide the iPod 30-pin connector to the left position and then place the nano
adapter into the docking area.
After removing the nano adapter remember to slide the 30-pin connector back
to the right position before attempting to install any iPod®adapter.
3.) After installing the necessary adapter in the docking area and making sure
that it is locked in place, insert your iPod® into the adapter so that the 30-pin
connector in the docking area is fully inserted into the 30-pin socket on the
bottom of your iPod.
58
HPI500FR-GBIM0236.indd 58 09/06/2006 16:38:32