LEXIBOOK HPl500 Manuel D'instructions page 41

Protect Your Furniture
This model is equipped with non-skid rubber 'feet' to prevent the
product from moving when you operate the controls. These 'feet' are made from
non-migrating rubber material specially formulated to avoid leaving any marks
or stains on your furniture. However certain types of oil based furniture polishes,
wood preservatives, or cleaning sprays may cause the rubber 'feet' to soften,
and leave marks or a rubber residue on the furniture. To prevent any damage to
your furniture we strongly recommend that you purchase small self-adhesive felt
pads, available at hardware stores and home improvement canters
everywhere, and apply these pads to the bottom of the rubber 'feet' before you
place the product on fine wooden furniture.
Battery Back-up System
This unit includes a battery back up system powered by a built-in, long life
CR2430 lithium battery. The battery maintains the time and alarm settings, the
Sleep and Nap timer settings, and the preset station tuner memories as well,
whenever the power is interrupted. If the power is lost the display will go off and
the system will not operate. However once the power is restored the clock will
again reset itself and all of your other settings will be correct.
The lithium battery that was installed in your system can supply back up
memory power for up to 5 years or even longer. The actual effective life of
the lithium battery will be affected by the length of time between the date the
battery was installed at our factory and the date that you connected your unit to
your AC outlet, and by the number and duration of the power outages that you
experience in your home. To maximize the life of the back up battery this system
should be connected to an AC outlet that is always "live". When the lithium
battery begins to weaken, the low battery indicator " low" will begin to
flash in the display. When you see this flashing indicator you should replace the
lithium battery as soon as possible. Instructions for replacing the lithium battery
will be found at the end of this user guide.
Power Source
This system is designed to operate on 230V AC 50Hz house current only.
Connecting this system to any other power source may cause damage to the
system and such damage is not covered by your warranty.
41
HPI500FR-GBIM0236.indd 41 09/06/2006 16:37:59