LEXIBOOK HPl500 Manuel D'instructions page 54

5.) A few seconds after you release the tuning controls the display changes from
radio frequency back to the correct time. To see the station frequency again,
press the Time button on the top panel. The display will change from time to
radio frequency for a few seconds and then return to the correct time again.
6.) Adjust the volume to the desired level by pressing the Volume + or – buttons
on the top panel or the remote control. The volume level appears in the display
when the volume is adjusted.
The display level ranges "00" (minimum) to "63" (maximum).
7.) When you are finished listening press the Power button on the top panel
or the remote control to shut the system 'Off'. The TUNER indicator goes off.
NOTE: The Tuner remembers the last station that you were listening to and
the selected volume level, and automatically returns to the same station and
volume level when the system is switched 'On' again.
Presetting Stations In The Tuner Memory
You can store a total of 20 stations, 10 FM and 10AM, in the tuner memory for
easy recall at any time.
1.) Using either the Automatic or Manual Tuning method described above, tune
to the first station you wish to store in the tuner memory. Example: FM 92.5
MHz
2.) When the desired frequency appears on the display, press the Memory
button on the top panel once.
"F 1" will begin flashing on the display indicating that you can now store your
station in FM Preset Memory #1.
54
HPI500FR-GBIM0236.indd 54 09/06/2006 16:38:25