saro SVM Manuel D'utilisation page 50

BEDIENUNGSANLEITUNG/ USER MANUAL/ MANUEL D'UTILISATION
REPLACING TEFLON TAPE
Make sure the seal bar is cleaned properly before placing new Teflon.
Remove the protection layer
from the Teflon.
Cut the Teflon at the end of
the end block till the table is
reached.
Fold the Teflon against the
seal bar.
Version 12.10 Art. 0894552
.
Place the Teflon to the edge on
the end block, and push the
Teflon firmly on the seal bar.
Cut the Teflon at the edge.
for correct parts and quantities
Then roll over the seal bar
while pushing the seal bar to
the table.
Do this also on the other side.
Make sure the Teflon is placed
without wrinkles, they will
influence a proper seal result.
See page 22
Saro
Then stick the Teflon to the
other side. Prevent crinkles they
will influence the seal result.
Fold the remaining Teflon up
and push it against the end
block.
50