On/Off Switch - saro SVM Manuel D'utilisation

BEDIENUNGSANLEITUNG/ USER MANUAL/ MANUEL D'UTILISATION
STARTING AND OPERATING THE MACHINE

ON/OFF SWITCH

The ON/OFF switch is situated at the back side of the machine and is used to turn the machine on and
off before and after operation.
CAUTION – The ON/OFF switch does not completely remove all power from the machine. The power
cable must be unplugged from the wall socket to remove all power from the machine. Ensure that the
machine is completely without power during maintenance and repair activities is.
When the machine is turned on (with the ON/OFF switch), then the pump only runs during the vacuum cycle.
START MACHINE
When the machine is connected, then the machine can be turned on using the ON/OFF switch. When starting the
machine two cods first appear in succession on the display before control switches to user mode.
The first code indicates the control software version. The second code indicates the machines
active options. Note both codes on page 4 of this manual as they are important for the supplier or
SARO when making enquiries and/or if any problems arise.
After switching to user mode the machine is ready for use. If the machine is new or has not been
used for an extended period, then it is important to run the conditioning program for the pump (15
minutes) to maintain the pump. For instructions on the conditioning programme, see page 15.
After switching to the user mode the display could read [ OIL ]. This means that the operating
hours counter is turned on and the set number of operating hours has elapsed. The hour counter
is turned off by default but the client supplier can use it as a reminder for regular maintenance
activities.
When [Oil] is displayed the machine can be still be used as usual but it is advisable to either turn off the hour counter or
to reset it.
Contact SARO for more information about setting or turning off the operating hours counter.
Version 12.10 Art. 0894552
Saro
39