Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
to use liquid or gel washing detergents.
• Self Clean
It is suggested to run this program with certain
intervals (e.g. once in 1 or 2 months) for the
self-cleaning of your machine. This program
must certainly be run without any laundry in
the machine. Make sure that the machine is
empty before starting the program. For more
effective cleaning, you can run the program
by adding powder lime remover for washing
machines into compartment II of the detergent
drawer. After the program is completed, leave
the door ajar to allow the inside of the machine
get dry.
This is not a program for washing laundry.
C
This is a maintenance program for the
machine.
C
Never use this program if there is
something in your machine.
C
When this feature is started your machine
senses the load inside of it automatically, if
any, and interrupts the program.
Each of these main programs comprise of a
complete washing process, including washing,
rinsing and, if required, spin cycles.
C
Sort the laundry according to type of fabric,
color, degree of soiling and permissible
water temperature while choosing a
program.
C
Always select the lowest required
temperature. Higher temperature means
higher power consumption.
C
For further program details, see "Program
Selection Table
Economy Symbol
Shows energy saving programs and
temperature selections.
As "Intensive" and "Hygiene" programs are
long programs with higher temperature
selections to ensure hygiene, "Economy"
Symbol will not light up.
Special programs
For specific applications, select any of the
following programs:
• Spoelen (Rinse)
This program is used when you want to rinse
or starch separately.
• Centrifugeren+Pompen (Spin + Drain)
This program spins with maximum possible
rpm in the default setting after the water drains
from the machine.
C
Use a lower spin speed for delicate
laundries.
Temperature selection
Whenever a new program is selected, the
temperature anticipated for that program
appears on the temperature indicator (7b).
To change the temperature, press the
temperature button. Temperature decreases in
10° increments.
Cold selection is shown with "-" symbol.
Normally soiled, white cottons and
90˚C
linens. (Ex.: coffee table covers,
tablecloths, towels, bed sheets)
Normally soiled, fade proof colored
linens, cottons or synthetic clothes
60˚C
(Ex.: shirts, nightgowns, pajamas)
and lightly soiled white linen clothes
(Ex.: underwear)
Blended clothes including
40˚C
synthetics and woolens as well as
30˚C Cold
delicates.
Spin Speed selection
Whenever a new program is selected, the
maximum spin speed of the selected program
is displayed on the spin speed indicator.
To decrease the spin speed, press the "Spin"
button. Spin speed decreases gradually. Then,
rinse hold and no spin options are shown
respectively.
Rinse hold is shown with "
shown with "
If you are not going to unload your clothes
immediately after the cycle, you may use rinse
hold function in order to prevent your clothes
become wrinkled when there is no water in
the machine. With this function, your laundry
is kept in the final rinsing water. If you want to
spin your laundry after the rinse hold function:
- Adjust the spin speed.
- Press "Start/Pause/Cancel" button.
Program resumes. Your machine drains the
water and spins your laundry.
You can use no spin function in order to drain
the water without spinning at the end of the
program.
49 - EN
" and no spin is
" symbols.
Publicité
Table des Matières
